日本不卡一区,亚洲男同帅gay片在线观看,6080YYY午夜理论AA片,丝袜 亚洲 另类 欧美 变态

en CN

Product Details

Advantages of exothermic welding tools

1.The current carrying capacity (melting point) of the welding joint of the exothermic welding tool is the same as that of the conductor, and has good electrical conductivity. After detection, the DC resistance ratio change rate before and after welding is close to zero. This is unmatched by any kind of traditional connection.

2.The welding points of exothermic welding tools are molecularly bonded, permanent, and do not age.

3.The welding points of exothermic welding tools are not affected by corrosion like copper.

4.It will not be damaged by high surge current. The test shows that the conductor melts before the welding joint under the impact of short time high current

5.Exothermic welding tools are easy to operate, simple, and do not require professional personnel.

6.The heat release welding tool is simple, light, easy to carry and easy to operate

Precautions for the use of exothermic welding tools:

1.Before the construction and operation of the exothermic welding tool, it must be ensured that the welded part is free of dirt, and there is no welding slag block or welding slag powder left in the investment cavity and mold cavity.

2.Before the construction and operation of the exothermic welding tool, it is necessary to use the spray torch (or gas torch) to dry the welded part and the investment mold, so that it is as free of moisture as possible.

3.In the construction operation of exothermic welding tools, before ignition, it must be ensured that the investment cover is covered and there is no crack in the closure of the investment mold.

4.In the construction operation of exothermic welding tools, before ignition, it must be ensured that the welding point of the welded part is located in the center of the cavity.

5.During the construction and operation of exothermic welding tools, no irrelevant personnel shall stay within 1.50 meters of the site.

6.During the construction and operation of exothermic welding tools, no flammable materials shall be placed within the range of 1 to 2 meters on the site.

7.Operators must wear work gloves with a certain heat insulation effect.

8.The operator shall not face the investment mold opening to operate.

9.During ignition, once the ignition powder is ignited, the operator must immediately leave the investment mold at least 1.50 meters away.

10.When the exothermic flux reaction is complete, no person shall directly contact the investment mold and the welded part.

11.When the exothermic flux reaction is finished, the investment mold and the welded part must be cooled naturally for 10-20 seconds, and the vice (or similar tool) is used to remove it from the investment mold.

12.The insulation treatment of the welded part must be carried out  after the wire is completely cooled.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

0086-532-80679022